耳机放大器电路 (Headphone Amplifier)

Amplifier parts:

P1_____________22K   Log.Potentiometer (Dual-gang for stereo)

R1____________560R   1/4W Resistor
R2,R3__________10K   1/4W Resistors
R4_____________12K   1/4W Resistor
R5,R6___________2R2  1/4W Resistor
R7_____________22R   1/2W Resistor

C1______________1΅F   63V Polyester Capacitor
C2,C3,C4______100΅F   25V Electrolytic Capacitors
C5_____________22pF   63V Polystyrene or Ceramic Capacitor
C6_____________22΅F   25V Electrolytic Capacitor

IC1___________LM833 or NE5532 Low noise Dual Op-amp

Q1,Q3_________BC337   45V 800mA NPN Transistors
Q2,Q4_________BC327   45V 800mA PNP Transistors

J1______________RCA  audio input socket

Power supply parts:

R7______________2K2  1/4W Resistor

C7,C8________2200΅F   25V Electrolytic Capacitors

D1____________100V 1A Diode bridge
D2____________5mm. or 3mm. Red LED

IC2___________7815  15V 1A Positive voltage regulator IC
IC3___________7915  15V 1A Negative voltage regulator IC

T1____________220V Primary, 15 + 15V Secondary 5VA Mains transformer

PL1___________Male Mains plug

SW1___________SPST Mains switch

Notes:

Can be directly connected to CD players, tuners and tape recorders.

Tested with several headphone models of different impedance: 32, 100, 245, 300, 600 & 2000 Ohms.

Can drive old 8 Ohms impedance headphones, but these obsolete devices are not recommended.

Schematic shows left channel and power supply.

Numbers in parentheses show IC1 right channel pin connections.

A correct grounding is very important to eliminate hum and ground loops. Connect in the same point the ground sides of J1, P1, C2, C3 & C4. Then connect separately the input and output grounds at the power supply ground.

Technical data:

Output voltage: Well above 5V RMS on all loads

Sensitivity: 250mV input for 5V RMS output

Frequency response: Flat from 30Hz to 20KHz

Total harmonic distortion @ 1KHz & 10KHz: Below 0.005% on 32 Ohms load and up to 4V RMS output (typical 0.003%)
Total harmonic distortion @ 1KHz & 10KHz: Below 0.005% on 100 to 2000 Ohms load and up to 5V RMS output (typical 0.003%)

Unconditionally stable on capacitive loads